Booting xen using uboot+efi on Rock64

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|

Booting xen using uboot+efi on Rock64

Todd Stellanova
Hello,

I'm trying to get Xen running on the Rock64 SBC (Rockchip RK3328).
The long details of my setup are here: https://forum.pine64.org/showthread.php?tid=6059

Basically I'm at a point where I am able to manually kick off efi boot from a uboot command line and getting a couple of errors (FDT_ERR_BADMAGIC and one that looks like it's coming from the EFI loader)-- see the output from uboot below.

Any suggestions on what to try next?

```

=> set devtype mmc

=> set devnum 1

=> set distro_bootpart 6

=> run boot_efi_binary

reading efi/boot/bootaa64.efi

885072 bytes read in 129 ms (6.5 MiB/s)

libfdt fdt_check_header(): FDT_ERR_BADMAGIC

## Starting EFI application at 02000000 ...

Card did not respond to voltage select!

mmc_init: -95, time 10

Scanning disk [hidden email]...

Scanning disk [hidden email]...

Found 2 disks

Xen 4.11-rc (c/s Tue May 1 09:03:13 2018 +0100 git:0306a1311d) EFI loader

Couldn't obtain the File System Protocol Interface: ErrCode: 0x8000000000000003

## Application terminated, r = 0

```

_______________________________________________
Xen-users mailing list
[hidden email]
https://lists.xenproject.org/mailman/listinfo/xen-users